Yes, I had tried that syntax as well with the same results X-Ascend-Data-Filter =~ ".*",
just to go back one step. I used cvs source and did ./configure --with-ascend-binary ; make ; make install ----- Original Message ----- From: "Chris Parker" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Thursday, March 21, 2002 6:08 PM Subject: Re: problems w/Ascend-Data-Filter and attr_filter module > At 05:35 PM 3/21/2002 -0500, FreeRadius wrote: > >I downloaded the cvs and recompiled and am having the same issue. > > > > > >radiusd: Starting - reading configuration files ... > > > >radiusd: /usr/local/etc/raddb/attrs[107]: Syntax error: Previous line is > > > >missing a trailing comma for entry realm.com > > > >/usr/local/etc/raddb/attrs (remove X-Ascend-Data-Filter != 0, and radius > >starts fine) I have tried several variation on the expression match for that > >attribute and get the same results. If I place the X-Ascend-Data-Filter != 0 > >at the end of the section in attrs file radius starts but doesn't proxy the > >attribute. > > > >realm.com > > Service-Type == Framed-User, > > Framed-IP-Address == 255.255.255.254, > > Framed-IP-Netmask == 255.255.255.255, > > Framed-Protocol == PPP, > > Framed-Compression == Van-Jacobson-TCP-IP, > > Framed-Filter-ID =~ ".*", > > Reply-Message =~ ".*", > > Session-Timeout != 0, > > Idle-Timeout != 0, > > X-Ascend-Data-Filter != 0, > > What are you trying to accomplish with that line? If you want to > allow any X-Ascend-Data-Filter attributes through, use the following: > > X-Ascend-Data-Filter =~ ".*", > > The comparison functions are overloaded depending on what type of > Attribute it is you are comparing. > > -Chris > -- > \\\|||/// \ StarNet Inc. \ Chris Parker > \ ~ ~ / \ WX *is* Wireless! \ Director, Engineering > | @ @ | \ http://www.starnetwx.net \ (847) 963-0116 > oOo---(_)---oOo--\------------------------------------------------------ > \ Wholesale Internet Services - http://www.megapop.net > > > > - > List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html > - List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
