Hallo, thanks for the replies.
If I insert only the Cisco-AVPair attribute, it doesn't work...
Now I try the "radius-server vsa send authentication" command...
It is a AP console command? It is possible to set this command from the
AP web interface?
I haven't experience with the console setting....
Another question:
Where can I find the list of the user attributes for freeradius?
Here http://www.freeradius.org/rfc/attributes.html for example I can't
find the Cisco-AVPair attribute...
Thanks a lot
Bye Antonio
James J J Hooper ha scritto:
--On Wednesday, March 29, 2006 09:11:13 +0100 Guy Davies
<[EMAIL PROTECTED]> wrote:
You *may* need to change them from being check attributes to reply
attributes if your AP doesn't actually send those attributes with an
Access-Request. In that case, you send the Cisco-AVPair =
"SSID=SSIDn" back to the AP and if it doesn't match, then it can
locally fail to authorize the user.
I don't think 1200's do send the attribute by default in the
access-request. To make it do so, use this command:
radius-server vsa send authentication
Regards,
James
--
James J J Hooper,
Information Services
University of Bristol
--
- List info/subscribe/unsubscribe? See
http://www.freeradius.org/list/users.html
--
----------------------------------------------
Antonio Matera
CREATE-NET
Via Solteri, 38 - 38100 Trento
e-mail: [EMAIL PROTECTED]
phone: +39 0461 408400 ext. 305
fax: +39 0461 421157
www.create-net.org
----------------------------------------------
-
List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
