Hi,
Not sure this answers your question but..
I use the following setup for extreme switches..
############
# Access layer
admin NAS-IP-Address == 192.168.0.9, Auth-Type = System
Service-Type = Administrative-User
############
Administrative-User = Read/Write
Login-User = Read only
Best Regards
Mats Blomgren B
-----Original Message-----
From:
freeradius-users-bounces+mats.b.blomgren=ericsson....@lists.freeradius.org
[mailto:freeradius-users-bounces+mats.b.blomgren=ericsson....@lists.freeradius.org]
On Behalf Of Wagner Pereira
Sent: den 15 april 2010 16:26
To: FreeRadius users mailing list
Subject: What nastype for Extreme switch?
Hi, all.
I installed the AAA model Radius on my Extreme's switch and I am already able
to log in into it, but I just enter in this device through the non-privileged
mode ( > ).
I was taking a look at http://linux.die.net/man/5/clients.conf and it says:
----------------------------
nastype
The nastype attribute is used to tell the checkrad.pl script which NAS-specific
method it should use when checking simultaneous use.
The following values are currently recognized:
cisco
computone
livingston
max40xx
multitech
netserver
pathras
patton
portslave
tc
usrhiper
other
----------------------------
Which of these nastype values I must to use for Extreme devices?
Thanks.
--
Wagner Pereira
PoP-SP/RNP - Ponto de Presença da RNP em São Paulo CCE/USP - Centro de
Computação Eletrônica da Universidade de São Paulo http://www.pop-sp.rnp.br
Tel. (11) 3091-8901
-
List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
-
List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
