I was trying to follow your suggestions, I was just confused about them. I wasn't sure what I needed to be adding to inner-tunnel. I did end up adding a line to proxy.conf, but it was just a blank entry for the testlab.netrealm. After that, authentication worked when using the u...@realmformat. I have other issues with it at this point, which I believe is outside the scope of the original problem.
I am still not 100% on the inner-tunnel settings I need to configure, however I am still trying to figure it out. I read through inner-tunnel but just ended up getting a bit more confused than I already was. >What did my message say? >If you're not going to follow my suggestions, I don't see why you're >asking questions on this list. I wasn't trying to ignore your advice, again, I was just confused. Thanks for the help, though. On Wed, Oct 20, 2010 at 1:03 AM, Alan DeKok <[email protected]>wrote: > Ryan Garrett wrote: > > There must be something I am not understanding, as I am unclear on what > > I need to be adding to proxy.conf. > > You need to inform the server that "u...@realm" should be treated the > same as "user". > > > And from what I can tell, > > inner-tunnel doesn't need to be touched with the way I am configuring, > > or is that incorrect? > > > > > In 2.1.10, read raddb/sites-available/inner-tunnel. Test that with > > "radtest" and "[email protected] <mailto:[email protected]>". > > Once that works, PEAP will work. > > Alan DeKok. > - > List info/subscribe/unsubscribe? See > http://www.freeradius.org/list/users.html >
- List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
