Fajar A. Nugraha wrote: > Norman Diamond wrote: >> Fajar A. Nugraha wrote: >>> Norman Diamond wrote: >>>> Fajar A. Nugraha wrote: >>>>> >>>>> What does the debug log show? >>>> >>>> OK, I ran radiusd -XXXC and it's the same. >>>> Output lines now have the word Debug in them but >>>> the contents are the same. It successfully >>>> links to rlm_realm and configures that, as used >>>> by inner-tunnel. (If I unconfigure sql in >>>> inner-tunnel then the last successful operation >>>> comes somewhat later in default.) Immediately >>>> after that success, it says: >>>> Failed to load module "sql". >>>> It does not give any additional information >>>> about what part of the load operation failed. >>> >>> From http://wiki.freeradius.org/Radiusd >>> "Ask questions on the mailing list. When asking >>> questions, include the output from debugging mode >>> ( radiusd -X ). This information will allow >>> people to help you. Without it, your message will >>> get ignored." >> >> Yahoo's web mail interface wraps lines, sorry. > > If you just use "radiusd -X" (like the wiki says) > the output would be much easier to read.
I think readability would be the same. I had expected radiusd -XXXC to produce more lines of output than radiusd -XC but it didn't (or at least not any that I noticed). Insertion of the word Debug slightly lengthened the lines but even without that the lines still would get wrapped by Yahoo's web mail. >> Anyway I think you'll detect that my wording >> described the output: >> [...] >> /etc/raddb/sites-enabled/inner-tunnel[118]: Failed >> to load module "sql". > > ... and if you've included the debug output from > start you'd see that sql.conf was never loaded. YOU saw that and I thank you. I would not have known to look for that. The reason follows below. > Probably because you haven't bothered looking at > radiusd.conf and uncomment the line > > # $INCLUDE sql.conf Because I didn't guess that radiusd.conf had such a change between version 2.0.5-8.3 in OpenSuse 11.0, and version 2.1.9-1.7 in OpenSuse 11.3. Thank you for pointing that out. YOU knew about the change and I thank you. I did not know about the change. > without that, the sql module is not initialized, and > would give an error when you call "sql" in the > config file. I understand. I thank you again. Please note that my initial posting to this discussion asked what changed between those two versions to break the use of SQL, and here you have answered. I thank you for answering. I think you could have answered directly that radiusd.conf changed and users need to look at it. Yours sincerely, Norman Diamond -------------------------------------- Get the new Internet Explorer 8 optimized for Yahoo! JAPAN http://pr.mail.yahoo.co.jp/ie8/ - List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
