Arran,
>* Let say for example in our Wireless AP (access point) we can put 2 Radius >server in sequence, radiusA and radiusB. I know the AP will eventually look at >the 1st server, and if its not available (let say server is down) then it will >go to the 2nd radius server (I only assume this). *>* *>* So is there any way >in Radius conf we can set the retries or timeout, so for example after failed >for 2 times (no matter what is the error is) it will goes to the other radius >server? * You're asking whether you can configure FreeRADIUS to inform the access point that it should fail over to another server server after a given number of timeouts/retries? Or are you talking about failing over between upstream proxy servers? -Arran "Or are you talking about failing over between upstream proxy servers?" Does this mean a setup of Radius load balancing? I mean a few Radius server that used by the same AP ? So from AP point of view i just need to point to the "master" Ip address of the first radius server? Thanks Danny On Fri, Mar 1, 2013 at 3:27 PM, Danny Kurniawan < [email protected]> wrote: > No worries, i receive this mailing list on my email now.. > > OK, so i also understand that we can only configure that from the AP side. > But unfortunately we cant find that in the Meraki AP ... let me check with > our vendor on it. > > Thanks > Danny > > On Fri, Mar 1, 2013 at 2:26 PM, Arran Cudbard-Bell < > [email protected]> wrote: > >> >> On 1 Mar 2013, at 00:20, Danny Kurniawan < >> [email protected]> wrote: >> >> > Out of topic : All, btw how can i make sure that when i reply in this >> mailing list it appears after the previous post ? I dont receieve any of >> your reply in my email and i have to go to the archive list to reply this. >> >> I'm not sure what you're asking... >> - >> List info/subscribe/unsubscribe? See >> http://www.freeradius.org/list/users.html >> > > > > -- > Best Regards, > Danny > -- Best Regards, Danny
- List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
