that sounds about right depending on the size of the patch. Did it work?
On Wed, 31 May
2006, adam walczak wrote:
about how long should the flattening process take?
mris_flatten took about nine hours when I tried it
yesterday.
adam
--- Bruce Fischl <[EMAIL PROTECTED]> wrote:
use tksurfer.
On Wed, 31 May 2006, adam walczak wrote:
Hello,
I was searching through the wiki and ran across a
page
that said to use csurf to make full surface cuts
in
order to ultimately create flattened surfaces.
But
while perusing the support archives, it was said
that
csurf is no longer supported. Is this true? How
then
do you make the full surface cuts needed to create
the
flattened surfaces?
Thanks
Adam
adam
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam
protection around
http://mail.yahoo.com
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
adam
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
