p{margin:0;padding:0;}
Hello,
I'm a FreeSurfer beginner and would like to ask a question about Choi's
stratium parcellations. I was doing a research to incoorporate the
parcellations by Choi on my subjects' images to delve further to understand the
distincitve characteristics of each parcels. I decided to use the
Choi2012_7Networks_MNI152_FreeSurferConformed1mm_LooseMask.nii.gz. Since my
images were on the standardized model from FSL, I transformed Choi's image to
the MNI standard using FIRST of FSL. Since both images were now on the same MNI
space, I viewed both of them on FSL to make sure that the Loose mask covered my
image completely, but found that the tail bit of my image was a couple of
pixels too longer than Choi's Loosened mask. Do you think there is a way that I
can further "loosen" up Choi's image to fit my image? Or can you recommend me a
different solution to this problem?
I'll wait for your reply. Thanks!
Sincerely, Sooyun Cho.
_______________________________________________
Freesurfer mailing list
[email protected]
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
