Hi, I’m using FreeSurfer 5.3.0 on OS X 10.9.1. I seem to have run into a GUI bug. When I go to Configure Overlay Display and change the Min setting the display range changes appropriately on the figure once I press the Apply button. When I change the max setting (e.g., from 5 to 50) the Histogram changes appropriately when I press Apply (the green line moves to 50) but nothing changes on the figure. Furthermore, if the color scale is displayed, the scale ends are unchanged (still 5). If I press Close and then open it up again the Max is no longer changed (still 5) and the Histogram now displays the unchanged value (green line at 5). If, however, I change the Max by right-clicking then not only does the histogram change (without needing to press Apply) but also the figure once I press Apply.
Cheers! Joe Cut-and-paste the following info into your FreeSurfer problem report: --------------------------------------------------------------------- FREESURFER_HOME: /Applications/freesurfer Build stamp: freesurfer-Darwin-lion-stable-pub-v5.3.0 Kernel info: Darwin 13.0.0 x86_64 --------------------------------------------------------------------- Please include the following additional information in your report: 1) tksurfer overlay color range control bug report 2) tksurfer fsaverage lh inflated -aparc -overlay AP1-fusiform-voxel-ST-FacSF1lh.nii.gz 3) none 4) not relevant See also: http://surfer.nmr.mgh.harvard.edu/fswiki/BugReporting which tksurfer /Applications/freesurfer/bin/tksurfer -------------------------------------------------------------------------------- Joseph Dien, Senior Research Scientist Maryland Neuroimaging Center University of Maryland E-mail: [email protected] Phone: 202-297-8117 http://joedien.com
_______________________________________________ Freesurfer mailing list [email protected] https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
