Hi James
if you upload a problem subject we will take a look (the whole subject dir
please)
cheers
Bruce
On Fri, 11 Jul 2014,
james pardon wrote:
Hi all,
On a few subjects with a specific pathology (MS) I cannot easily reconstruct
temporal lobes.
I think this issue comes up quite regularly on the mailing list, and I have
tried to trouble
shoot using control points, WM edits, even getting back to orig/001.mgz to
correct areas that
may seem the culprit for breaking surface reconstruction. Some subjects have
gone through 7-8
runs of recon-all with different edits but still the problem persists in a few
subjects in my
study.
I have also tried to use -mprage and -3T flags along the way to allow more
liberal control
point growing, despite an improvement in my results some of subjects still have
very bad
surface constructions. I have attached two snapshots to this email and I am
happy to upload
the complete subject folder if you need to take a look at them.
As far as the SNR is concerned, I have designed my study based on recommended
Freesurfer
parameters a couple of years ago on 3T Siemens Trio with 32-channel receiver
coil.
A huge thank you for your previous helps, and thanks in advance for helping me
with this new
issue.
James
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.