No, you'll need to pass the new registration to mri_vol2surf. You should
also check that freeview is producing the correct registration file.
We've had several problems with it that are definitely fixed in 6.0, but
not sure about 5.3. Try loading it in tkregister (--lta your.lta --reg
your.reg --ltaout your.lta). In fact, I would probably just not use
freeview to adjust the registration in 5.3, use tkregister.
On 3/23/16 7:55 AM, Elijah Mak wrote:
Hi Doug,
Thanks!
I manually tweaked the registration of the PET to T1 on a number of
subjects to bring the mincost down to < 0.5. After saving the pet2free
volume in Freeview, I noticed that a new .lta is produced in the same
directory (i.e. pet2free_fsl.mgz.lta).
Will the option --regheader tell the subsequent commands (i.e.
mri_vol2surf) to use the updated registration .lta instead of the
original .dat that was produced via bbregister?
Best Wishes,
Elijah
_______________________________________________
Freesurfer mailing list
[email protected]
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
[email protected]
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
