Hi Peng, No, there is no command-line option for that. I will add it in future update.
Best, Ruopeng > On Jan 27, 2017, at 9:49 AM, peng <[email protected]> wrote: > > Dear Freesurfer experts, > > When I use Freeview GUI to show overlays on a surface, I can click on > the button "Configure", and then check the box "Enable" in the smooth > section (upper right of the pop-out window), to smooth it. Is there > any options to do similar stuff in the command line of freeview? e.g. > when I want to generate a lot of screenshots by the -ss option. > Thank you in advance! > > best > Peng > _______________________________________________ > Freesurfer mailing list > [email protected] > https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer > > _______________________________________________ Freesurfer mailing list [email protected] https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
