sure, our ftp site Bruce On Thu, 14 Dec 2017, Trevor K Day wrote:
Hi Bruce, My apologies, I had forgotten that we had set FREESURFER_HOME up in our pipelines separately, and had I just got the version off of my shell. We are using freesurfer-Linux-centos6_x86_64-stable-pub-v6.0.0-2beb96c Should I upload the subject somewhere? Thanks, Trevor From: Bruce Fischl Sent: Thursday, December 14, 2017 7:06 AM To: Freesurfer support list Subject: Re: [Freesurfer] White/pial surface failure Hi Trevor would you consider moving to V6? The high res stream is *much* better in it than 5.3. If you can't, upload the subject and we will take a look cheers Bruce On Thu, 14 Dec 2017, Trevor K Day wrote: > > Hello, > > > > We are trying to run the high-resolution pipeline and it has failed spectacularly on one of our > subjects. > > Two images from recon_checker are attached. > > > > I’m stumped because the command exits with an exit code of 0 and, in looking at the log, there no > obvious indication of any error. > > I’m not sure what to search because I don’t have an error message. > > Recon-all.log is attached. > > > > The brainmask is fine. Not perfect, but certainly not poor enough to cause this. > > The intensity values of the T1 are perfectly normal, and there’s a bit of a motion artifact in the > frontal lobe, but nothing that freesurfer hasn’t handled before. > > > > Others have suggested that this seems to extreme to fix with control points, are the other > approaches to take? > > > > The command used was: > > > > /usr/local/freesurfer/stable6_0/bin/recon-all \ > > -all -s 170661.s1 -hires -cw256 -qcache \ > > -i /mnt/panuc/udallp2/subjects/170661/session1/mprage/T1_256.nii.gz \ > > -expert /mnt/panuc/udallp2/lib/expert.opts > > > > (Again, T1_256.nii.gz looks totally fine.) > > > > The contents of expert.opts are mris_inflate -n 30 > > > > * Freesurfer version: freesurfer-Linux-centos6_x86_64-stable-pub-v5.3.0 > * Platform: Debian GNU/Linux 8.9 (jessie) > * Uname -a: Linux panuc 3.16.0-4-amd64 #1 SMP Debian 3.16.43-2+deb8u5 (2017-09-19) x86_64 > GNU/Linux > > > > Where can I start to debug and fix this? > > > > Thanks, > > Trevor Day > > >
_______________________________________________ Freesurfer mailing list [email protected] https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
