External Email - Use Caution
Hi all,
I try to run dt_recon on my dicom files, acquired with a siemens scanner unsing the command from the wiki.
The dwi.nii.gz and the dwi-ec.nii.gz as well as the bval and bvec files are generated without problems. Then following error massage is displayed:
" .../dwi-ec.nii.gz
... done reading.
MatrixReadTxt: could not scan value [1] [1]
WARNING: matlab element type is 1853121906, which is not a matrix.
could not allocate 811886962 x 1600270640 matrix
Cannot allocate memory
unsupported matlab format 1918988400 (unknown)
Cannot allocate memory"
I think the error is right in the beginning of the DTI GLM Fit and tensor construction, I think a matrix is missing. But when I only try to do dt_recon for one subject I am not sure which kind of matrix I should define and how to give the correct matrix in the command line.
Does anybody have an idea? I also tried "--init-fsl" because matlab is only recquired for init-spm, but that doesn't work as well.
Does anybody have an idea? I also tried "--init-fsl" because matlab is only recquired for init-spm, but that doesn't work as well.
Thanks a lot!!
Best regards,
Michelle
Michelle
_______________________________________________ Freesurfer mailing list [email protected] https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Mass General Brigham Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline <https://www.massgeneralbrigham.org/complianceline> . Please note that this e-mail is not secure (encrypted). If you do not wish to continue communication over unencrypted e-mail, please notify the sender of this message immediately. Continuing to send or respond to e-mail after receiving this message means you understand and accept this risk and wish to continue to communicate over unencrypted e-mail.
