Dear Surfers,
I am using freesurfer 7.1.1 to view flattened patches and I have faced
two issues:
1) When I elevate the camera (see the command below), the loaded image is
not centered. Is there any command (key) to recenter the image other than
manually moving it?
2) The "measure" bottom is not active and I can't find any way to show
the 1 cm scale bar.
This is the command line that I am using to load the image:
freeview -f <Subject
Folder>/surf/rh.inflated:patch=rh.occip_patch.flat:curvature=<Subject
Folder>/surf/rh.curv.subdiv.B1justsub.mgh:edgethickness=0:annot_outline=1:overlay=<FMRI
Data>/sig.nii.gz:overlay_threshold=2,4 -viewport 3d -zoom 1.2 -cam Elevation 90
Regards,
Shahin Nasr, Ph. D.
Assistant Professor in Radiology
Harvard Medical School
https://mesovision.martinos.org/
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline
<https://www.massgeneralbrigham.org/complianceline> .
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.
