Just sample the activation onto the full surface (eg, --surf white
--projfrac 0.5), then just load it as an overlay when you view the patch
in freeview
On 2/22/2024 12:18 PM, Atena Akbari wrote:
External Email - Use Caution
Hello Freesurfer team,
I have flattened the occipital patch using "mris_flatten -w 10
subj04/surf/lh.occip.patch.3d subj04/surf/lh.occip.flattened" and it
worked without any error and I can load the flattened patch in
freeview. However, I have difficulty overlaying the activation map
onto the flattened surface. Is the following command correct for this
purpose?
(mri_vol2surf --mov spmT_0001.nii --out
subj04/surf/lh.bold.flat.mgz --reg fsl_reg.dat.lta --surf
occip.flattened --hemi lh)
Many thanks,
Atena
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline
<https://www.massgeneralbrigham.org/complianceline> .
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.
