> a or A depending on if you want top down.. or bottom up. Okay, so with OpenZAP I can use either a number to refer to a specific port or A to refer to any available port in a span. Other than using a number or A (and a) OpenZAP currently has no mechanism for defining explicit pools / port ranges.
So to do something like have a four port card setup with inbound calls using all four ports and outbound calls using only ports 2 - 4 would I need to configure the card as two spans with span 1 containing port 1, and span 2 containing ports 2 - 4? Then I route outbound calls to span 2 using the A port (aka any available port on span 2)? -- John ------------------------------------------------------------------------- | Feith Systems | Voice: 1-215-646-8000 | Email: [EMAIL PROTECTED] | | John Wehle | Fax: 1-215-540-5495 | | ------------------------------------------------------------------------- _______________________________________________ Freeswitch-users mailing list [email protected] http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org
