We didn't make jira, It's a commercial solution that gives free license to open source projects. You could probably request the feature from them but if it is possible I have never known about it.
I always click the link at the top of the emails which puts you in the issue's main page so you can fill in comments. On Thu, Sep 25, 2008 at 1:18 PM, Martin Joseph <[EMAIL PROTECTED]> wrote: > > On Sep 23, 2008, at 7:13 AM, Anthony Minessale wrote: > > > I have moved your issue to http://jira.freeswitch.org/browse/ > > OPENZAP-18 > > since it's an openzap issue and not a build system issue. > > > > Please pay attention to the emails you receive regarding the issue > > and promptly reply to any comments. > > I must say that when I posted to the Jira and received emails > regarding my input, it was quite annoying that my responses to the > emails went to the bit bucket? > > I think it would be really helpful if the emails about Jira posts > could be replied to and then the replies could be incorporated back > into the Jira or at least reach the Jira admin. > > It a minimum making it much clearer that the emails cannot be replied > to and providing a link to the appropriate place to reply in the Jira > would be great. > > Just a thought, > Marty > > > > > > > > > > > > > On Tue, Sep 23, 2008 at 9:01 AM, palani sivagurunathan > > <[EMAIL PROTECTED]> wrote: > > > > > > Antony, > > > > Thanks for the reply .I have posted in http:// > > jira.freeswitch.org/browse/FSBUILD-79 > > > > > > Thanks & Regards, > > Palanivel.S > > > > > > > > On 9/22/08, Anthony Minessale <[EMAIL PROTECTED]> wrote: > > That shows the other end is sending a RESTART command. > > Can you make a trace of the debug log on the console or the logfile > > from mod_logfile showing the calls working and then on to when you > > get the issue including the several failed call attempts in their > > entirety and post them to http://jira.freeswitch.org under the > > openzap category. > > > > > > On Mon, Sep 22, 2008 at 9:29 AM, palani sivagurunathan > > <[EMAIL PROTECTED]> wrote: > > > > > > > > Hi, > > > > I have installed freeswitch through SVN in centos.OutBound is > > working fine .But not always .Once we make 8 to 10 call from a sip > > extension we get service unavailable error in xlite . Error and > > configuration are pasted below .we observed the problem is getting > > rectified after 5 to 10 mins .and we are able to make calls and > > again after 8 to 10 calls Errors happen > > > > how to check. what will be the issue > > > > > > my configuration is: > > > > > > wanpipe1.conf > > > > > > [devices] > > wanpipe1 = WAN_AFT_TE1, Comment > > > > [interfaces] > > w1g1 = wanpipe1, , TDM_VOICE_API, Comment > > > > [wanpipe1] > > CARD_TYPE = AFT > > S514CPU = A > > CommPort = PRI > > AUTO_PCISLOT = NO > > PCISLOT = 9 > > PCIBUS = 0 > > FE_MEDIA = E1 > > FE_LCODE = HDB3 > > FE_FRAME = CRC4 > > FE_LINE = 1 > > TE_CLOCK = NORMAL > > TE_REF_CLOCK = 0 > > TE_SIG_MODE = CCS > > TE_HIGHIMPEDANCE = NO > > LBO = 120OH > > FE_TXTRISTATE = NO > > MTU = 1500 > > UDPPORT = 9000 > > TTL = 255 > > IGNORE_FRONT_END = NO > > TDMV_SPAN = 1 > > TDMV_DCHAN = 16 > > TDMV_HW_DTMF = NO > > > > [w1g1] > > ACTIVE_CH = ALL > > TDMV_ECHO_OFF = NO > > TDMV_HWEC = YES > > MTU = 80 > > > > > > openzap.conf > > > > [span wanpipe] > > name => OpenZAP > > number => 1 > > trunk_type => E1 > > b-channel => 1:1-15 > > d-channel => 1:16 > > b-channel => 1:17-31 > > > > > > openzap.conf.xml > > > > <configuration name="openzap.conf" description="OpenZAP > > Configuration"> > > <settings> > > <param name="debug" value="0"/> > > </settings> > > <pri_spans> > > <span id="1"> > > <param name="mode" value="user"/> > > <param name="dialect" value="euro"/> > > <param name="dialplan" value="XML"/> > > <param name="context" value="default"/> > > </span> > > </pri_spans> > > </configuration> > > > > > > > > default.xml > > <?xml version="1.0" encoding="utf-8"?> > > <!-- http://wiki.freeswitch.org/wiki/Dialplan_XML --> > > <include> > > <context name="default"> > > <extension name="Long Distance - wanpipe"> > > <condition field="destination_number" expression="^9(\d > > {5,15})$"> > > <action application="set" data="dialed_ext=$1"/> > > <action application="bridge" data="OpenZAP/1/a/$ > > {dialed_ext}"/> > > </condition> > > </extension> > > </context> > > </include> > > > > > > > > After starting the freeswitch . In console i type oz dump 1 a > > > > > > my status before calling is: > > > > span_id: 1 > > chan_id: 16 > > physical_span_id: 1 > > physical_chan_id: 16 > > type: DQ921 > > state: UP > > last_state: DOWN > > cid_date: > > cid_name: > > cid_num: > > ani: > > aniII: > > dnis: > > rdnis: > > cause: NONE > > > > my (oz dump 1 a) status After calling is: > > > > span_id: 1 > > chan_id: 16 > > physical_span_id: 1 > > physical_chan_id: 16 > > type: DQ921 > > state: UP > > last_state: DOWN > > cid_date: > > cid_name: > > cid_num: > > ani: > > aniII: > > dnis: > > rdnis: > > cause: NONE > > > > But while i try to make a outbound call continously, i am getting > > following error > > > > [08 02 00 00 4e 18 03 a1 83 81 79 01 80] > > > > 2008-09-23 01:05:50 [DEBUG] Span:0 Q.931() Sending message to > > Layer4 (size: 119) > > 2008-09-23 01:05:50 [DEBUG] ozmod_isdn.c:319 zap_isdn_931_34() Yay > > I got an event! Type:[46] Size:[119] CRV: 0 (0, CTX: Originator) > > 2008-09-23 01:05:50 [DEBUG] ozmod_isdn.c:351 zap_isdn_931_34() > > zchan 0 (-1:-1) source isdn_data->channels_remote_crv[0] > > 2008-09-23 01:05:50 [DEBUG] ozmod_isdn.c:399 zap_isdn_931_34() > > Changing state on 1:1 from DOWN to RESTART > > 2008-09-23 01:05:50 [DEBUG] Span:0 Q.931() Sending message to Q.921 > > (size: 119) > > 2008-09-23 01:05:50 [DEBUG] Span:0 Q.931() Creating Q.931 Message > > Header: > > ProtDisc 8 (0x8), CRV 0 (0), CRVflag: 0 (0), MesType: 78 (0x4e) > > 2008-09-23 01:05:50 [DEBUG] ozmod_isdn.c:1499 q931_rx_32() WRITE 13 > > ---------------------------------------------------------------------- > > ---------- > > [08 02 00 00 4e 18 03 a1 83 81 79 01 80] > > > > 2008-09-23 01:05:50 [DEBUG] ozmod_isdn.c:796 state_advance() 1:1 > > STATE [RESTART] > > 2008-09-23 01:05:50 [DEBUG] mod_openzap.c:1368 > > on_clear_channel_signal() got clear channel sig [RESTART] > > 2008-09-23 01:05:50 [DEBUG] ozmod_isdn.c:882 state_advance() > > Changing state on 1:1 from RESTART to DOWN > > 2008-09-23 01:05:50 [DEBUG] ozmod_isdn.c:796 state_advance() 1:1 > > STATE [DOWN] > > 2008-09-23 01:05:50 [DEBUG] zap_io.c:1088 zap_channel_done() > > channel done 1:1 > > > > > > > > > > > > > > > > > > -- > > > > > > Thanks & Regards, > > Palanivel.S > > > > > > _______________________________________________ > > Freeswitch-users mailing list > > [email protected] > > http://lists.freeswitch.org/mailman/listinfo/freeswitch-users > > UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch- > > users > > http://www.freeswitch.org > > > > > > > > > > -- > > Anthony Minessale II > > > > FreeSWITCH http://www.freeswitch.org/ > > ClueCon http://www.cluecon.com/ > > > > AIM: anthm > > MSN:[EMAIL PROTECTED] <[EMAIL PROTECTED]> > > GTALK/JABBER/PAYPAL:[EMAIL PROTECTED]<[EMAIL PROTECTED]> > > IRC: irc.freenode.net #freeswitch > > > > FreeSWITCH Developer Conference > > sip:[EMAIL PROTECTED] <[EMAIL PROTECTED]> > > iax:[EMAIL PROTECTED]/888 > > googletalk:[EMAIL PROTECTED]<[EMAIL PROTECTED]> > > pstn:213-799-1400 > > > > > > _______________________________________________ > > Freeswitch-users mailing list > > [email protected] > > http://lists.freeswitch.org/mailman/listinfo/freeswitch-users > > UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch- > > users > > http://www.freeswitch.org > > > > > > > > > > -- > > > > > > Thanks & Regards, > > Palanivel.S > > _______________________________________________ > > Freeswitch-users mailing list > > [email protected] > > http://lists.freeswitch.org/mailman/listinfo/freeswitch-users > > UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch- > > users > > http://www.freeswitch.org > > > > > > > > > > -- > > Anthony Minessale II > > > > FreeSWITCH http://www.freeswitch.org/ > > ClueCon http://www.cluecon.com/ > > > > AIM: anthm > > MSN:[EMAIL PROTECTED] <[EMAIL PROTECTED]> > > GTALK/JABBER/PAYPAL:[EMAIL PROTECTED]<[EMAIL PROTECTED]> > > IRC: irc.freenode.net #freeswitch > > > > FreeSWITCH Developer Conference > > sip:[EMAIL PROTECTED] <[EMAIL PROTECTED]> > > iax:[EMAIL PROTECTED]/888 > > googletalk:[EMAIL PROTECTED]<[EMAIL PROTECTED]> > > pstn:213-799-1400 > > _______________________________________________ > > Freeswitch-users mailing list > > [email protected] > > http://lists.freeswitch.org/mailman/listinfo/freeswitch-users > > UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch- > > users > > http://www.freeswitch.org > > > _______________________________________________ > Freeswitch-users mailing list > [email protected] > http://lists.freeswitch.org/mailman/listinfo/freeswitch-users > UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users > http://www.freeswitch.org > -- Anthony Minessale II FreeSWITCH http://www.freeswitch.org/ ClueCon http://www.cluecon.com/ AIM: anthm MSN:[EMAIL PROTECTED] <[EMAIL PROTECTED]> GTALK/JABBER/PAYPAL:[EMAIL PROTECTED]<[EMAIL PROTECTED]> IRC: irc.freenode.net #freeswitch FreeSWITCH Developer Conference sip:[EMAIL PROTECTED] <[EMAIL PROTECTED]> iax:[EMAIL PROTECTED]/888 googletalk:[EMAIL PROTECTED]<[EMAIL PROTECTED]> pstn:213-799-1400
_______________________________________________ Freeswitch-users mailing list [email protected] http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org
