I had the same problem a while ago with German PRI lines (S2M). Do you have <param name="dialect" value="q931"/> in your openzap.conf.xml?
In older Versions of openzap I used euro, in newer releases this didn't work any more, so I used q931. If this is not successfull, can you post your openzap.conf.xml and openzap.xml and the output of cat /proc/zaptel/* Best regards Peter [email protected] schrieb: > Hello, > > I'm a newbie in FS. > > I installed and configure Openzap and Zaptel. I have a PRI Digium Wildcard > TE110P. > > When I call a number then I get an Error! > > 2009-01-12 10:20:01 [CRIT] zap_io.c:804 zap_channel_open_any() All circuits > are busy. > 2009-01-12 10:20:01 [ERR] mod_openzap.c:910 channel_outgoing_channel() No > channels available > 2009-01-12 10:20:01 [ERR] switch_ivr_originate.c:926 switch_ivr_originate() > Cannot create outgoing channel of type [openzap] cause: > [DESTINATION_OUT_OF_ORDER] > > What's wrong? Do you need any configurations? > > Thanks! > Best Regards, Curly > > > _______________________________________________ Freeswitch-users mailing list [email protected] http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org
