Firstly I would try get get rid of the sangoma errors. There are 2 errors: Short Circuit: ON Loss of Signal: ON
So either the card is not configured correctly or there is a cabling problem. What is your wanpipe1.conf? Second, if euro doesn't work, try Q931. I had success with that some time ago. Best regards Peter Niall Crosby schrieb: > Hi, > > This might be Sangoma config issue, so apologies in advance for > posting it here if it is. I am waiting for Sangoma helpdesk to get > back to me! > > But I have a Sangoma a101 and trying to get it working with > Freeswitch. Have E1 line coming from telco and everything set up > correctly (to my best efforts), however when Freeswitch starts, it > says: > > 2009-07-30 15:17:15.446569 [ERR] mod_openzap.c:1953 Error starting > OpenZAP span 1 mode: user dialect: euro error: > > Also I'm getting the following Sangoma alarms: > > ***** w1g1: E1 Alarms (Framer) ***** > > ALOS: OFF | LOS: ON > RED: ON | AIS: OFF > OOF: ON | RAI: OFF > > ***** w1g1: E1 Alarms (LIU) ***** > > Short Circuit: ON > Open Circuit: OFF > Loss of Signal: ON > > > Can someone tell me where I should be focusing my attention - on the > Sangoma config or the Freeswitch config? > > Also what state should the Sangoma alarms be in when Freeswitch is NOT > running? Should they all clear? > > Thanks in advance, > Niall. > > > _______________________________________________ FreeSWITCH-users mailing list [email protected] http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org
