Hello,
i was reading through the openzap wiki page and searched the wiki, the
only thing I found about dahdi is a note from January that freeswitch
does not work with dahdi right now.
Is this current information? Can't I use dahdi kernel drivers for
freeswitch? As the last update to the zaptel drivers is now nearly a
year old (1.4.12) and development has, AFAIK, ceased and new stuff
only gehts to dahdi, correct me please if I am wrong.
Second question,
is it possible to use this hardware:
00:0d.0 Network controller: Cologne Chip Designs GmbH ISDN network
controller [HFC-PCI] (rev 02)
Subsystem: Cologne Chip Designs GmbH ISDN Board
Flags: bus master, medium devsel, latency 16, IRQ 10
I/O ports at e000 [disabled] [size=8]
Memory at ee001000 (32-bit, non-prefetchable) [size=256]
Capabilities: [40] Power Management version 1
Kernel modules: hisax
with openZap? I read in the wiki (openZap.conf_Examples) something
about HFC 4 BRI, but i do not know if this is the same as the above
mentioned card.
I have access to some pcmcia fxo, and pcmcia isdn cards, could they be
used? I have as well an soekris board with two pcmcia slots, could i
use this with an fxo pcmcia card to actually drive a small home - pbx
with freeswitch?
I did not find answers for this questions in the wiki :-)
best regards
--
Raimund Sacherer
-
RunSolutions
Open Source It Consulting
-
Email: [email protected]
tel: 625 40 32 08
Parc Bit - Centro Empresarial Son Espanyol
Edificio Estel - Local 3D
07121 - Palma de Mallorca
Baleares
_______________________________________________
FreeSWITCH-users mailing list
[email protected]
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org
