Hi Andrey, I tried the step which you mentioned but Ubuntu installation in compute node is getting failed and it is hanged at the below screen.
“Download debconf preconfiguration file Installation step failed” Thanks and Regards, Gandhi Rajan From: Andrey Danin [mailto:[email protected]] Sent: Thursday, July 03, 2014 4:40 PM To: Gandhirajan Mariappan (CW) Cc: [email protected]; Evgeniya Shumakher; '[email protected]' ([email protected]); Karthi Palaniappan (CW); Nataraj Mylsamy (CW); Harsha Ramamurthy; Raghunath Mallina (CW); Prakash Kaligotla Subject: Re: Deployment failed with error 'disk drive for /var/lib/nova is not ready or not present' Also you can reset the cluster, manually decrease a size of all the partitions of the Compute node a little it, and redeploy cluster again. On Thu, Jul 3, 2014 at 3:01 PM, Andrey Danin <[email protected]<mailto:[email protected]>> wrote: At first glance you can just skip the fsck and try to proceed w/o this partition. On Thu, Jul 3, 2014 at 1:56 PM, Gandhirajan Mariappan (CW) <[email protected]<mailto:[email protected]>> wrote: Diagnostic snapshot is available at https://www.dropbox.com/s/99roj5wmqltfx0v/fuel-snapshot-2014-07-03_09-20-12.tgz From: Gandhirajan Mariappan (CW) Sent: Thursday, July 03, 2014 12:18 PM To: [email protected]<mailto:[email protected]> Cc: Evgeniya Shumakher; Andrey Danin; '[email protected]<mailto:[email protected]>' ([email protected]<mailto:[email protected]>); Karthi Palaniappan (CW); Nataraj Mylsamy (CW); Harsha Ramamurthy; Raghunath Mallina (CW); Prakash Kaligotla Subject: Deployment failed with error 'disk drive for /var/lib/nova is not ready or not present' Hi Fuel Dev, While deploying the Controller and Compute node, deployment failed with below error in compute node. “fsck from util-linux 2.20.1 Fsck from util-linux 2.20.1 /dev/sda3: clean, 81860/1712128 files, 432026/6836480 blocks /dev/sda2: clean, 237/48960 files, 64942/195584 blocks The disk drive for /var/lib/nova is not ready or not present. Continue to wait, or press S to skip mounting or M for manual recovery” Note: Controller status is “Ubuntu is installed”, and Compute node is in Offline status since above error was displaying and it hanged at the page. Kindly let us know the procedure to make Compute node alive for deployment. Thanks and Regards, Gandhi Rajan -- Andrey Danin [email protected]<mailto:[email protected]> skype: gcon.monolake -- Andrey Danin [email protected]<mailto:[email protected]> skype: gcon.monolake
-- Mailing list: https://launchpad.net/~fuel-dev Post to : [email protected] Unsubscribe : https://launchpad.net/~fuel-dev More help : https://help.launchpad.net/ListHelp
