Mike Blanco wrote:
I am reading the document Getting started NG FP3 and it is talking about adding smart clients so that they can access the FW w/ a gui, but the doc does not tell you what smart center app you are suppose to use to do this.
---snipp---
Hi, if you are connected to the SSL-Webserver of SPlat, you are going through the first setup and here you can define Management Consoles (GUI, SmartConsole). So if you did this correctly and you aren't successful then with connecting to the Interface pointing to you, there might be some other reason. First of all check if the entry is correct. Log in at SPlat (maybe in expert mode) and have a look at it. You find the IP addresses from which you might connect to SmartCenter (Management - not Firewall) in the file $FWDIR/conf/gui-clients. For correcting an entry, you can either configure it using vi, or (better), use the command "cpconfig". If the IP address you are trying to connect your GUI from is correct, try the command "fw unloadlocal" and try to connect again. Then it should work. Please regard that after typing this command any security rule is active, but IP forwarding is disabled. Hope it helps, best regards, Matthias http:/www.fw-1.de -- AERAsec Network Services and Security GmbH Wagenberger Strasse 1 D-85662 Hohenbrunn, Germany http://www.aerasec.de
================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
