On Thu, Jul 08, 2004 at 11:10:04AM +0800, Alexander Simbun wrote: > I found out in Check Point website (under NG utilities), there is > a add-on utility , i.e. SNMP add-on for SecurePlatform NG with > Application Intelligence available for download. Is it possible to > install it on Check Point FW-1 NG AI (without SecurePlatform activated)? > I'm using NG AI and would like to monitor it using MRTG (if possible).
Most platforms come with their own snmp agent or you can install net-snmp (ucd-snmp). That will usually return disk space, interface statistics, cpu and load situations etc. Run cpconfig and enable Check Point's snmp agent (usually binds to port 260) and that will return most of the numbers that you see with Smartview Status: dropped, accepted, logged and rejected packets, CPU load, free space on the $CPDIR partition etc. tidbits. So to answer your question: I don't see the point in trying to make it work on other platforms. I'm pretty sure it'll probably run (i.e. it'll start if you extract the binary and launch it) on whatever Linux, but it was most likely intended to be used on Secureplatform. -- (Mr.) Hannu Liljemark | Appelsiini Finland Oy | http://appelsiini.fi ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
