On Thu, 26 Jun 2003 16:38:24 -0500, Bill Vader wrote: > Ok, I have the keyboard off again, is that the processor be under the > heatsink in the lower left side of the under-keyboard area? If so, is that a > handle that goes under the padded area next to the RAM? If that is so, why > do they have to use tiny Torx screws? I can never find that bit. > > Bill
Disconnect the backup battery (recommended by Apple)Pull the aluminum EMI shield out (center, held in with 2 screws). Now remove the screw that holds the aluminum heat exchanger to the case (just an inch or two left of center along the bottom edge where the keyboard was). The Processor board is centered next to the hard drive, find the tab at the drive end of the board and pull up. -- G-Books is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Check our web site for refurbished PowerBooks | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> G-Books list info: <http://lowendmac.com/lists/g-books.html> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/g-books%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
