DSL> Paradyne modem, one out put port > twisted pair crossover cable to> NetGear 614v2 router.
The NetGear 614 router has one Input Port for the DSL modem to connect and 4 output ports .
I have successfully hooked up a Pismo by CAT 5e cable from output port 1 on the Net Gear 614
I have a CAT 5e cable from the Net Gear router output port 2 to my Graphite Airport Base Station
The computer, a Pismo with an airport card sees the airport signal the airport base station is sending , but, will not make a connection, keep seeing different messages, unable to connect to that network, the TCP/IP is being used, even though I have selected the airport configuration and went in and checked the TCP/IP is selected to Airport and DCHP. Apple Talk is on.
I have made and used configurations for my dial up ISP, via the internal modem in the Pismo, dial up via the airport modem, dial up via earthlink ISP for Pismo internal modem. And Configuration via the ISP for DSL through the router via Cat 5 to the Pismo. All work fine and can select and use those configurations. Except Airport
I have tried to set up a configuration for the DSL airport =no go
followed all the steps, even tried using the set up assistant to re configure the base station and set up a new configuration. The base station has Apples latest updates
I used the base station modem on the Pismo for a couple of years
I have done all this in OS 9.2. Tried OS 10.3 but did not configure to airport either.
I am much better at 9 then X although at this point that statement is some what suspect, guess I knew I could back out of 9 where 10.3 would really turn a mess, anyway I will be using 9 and 10 on this little [EMAIL PROTECTED]( DSL network.
So does the connection from Net Gear Router Output 2 to the Graphite Base Station Ethernet connector have to be twisted wire cross over cable or Cat 5e cable And
Should the Net Gear Router Out Put Port 2 to the Airport Base Station Ethernet connection work and power airport with the DSL information so the pismos will recieve it .
Open to easy fixes, would seem to run the wire from the modem to the base station but then the network would stop. So are there splitters that go on the back of the DSL modem that would power the Net Gear 614 and the Netgear Router
Thanks for the patientce
Unwired in Big Lake
Geoff
FWIW
Computers I want to be able to use this and I have another Net Gear Hub, not a router just a Hub.
2 Pismos by airport 1 Gig of Ram 10.3 1 6100 Newer G3- 300 , 264 megs of Ram 6 gig 8.6 Hard drive Cat 5 1 laserweiter 360 Cat 5 1 HP 2410 Printer Cat 5 1 1400 G3 333mhz 64 mg RAM Cat5 by way of Card Bus modem/Ethernet
-- G-Books is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Check our web site for refurbished PowerBooks | & CDRWs on Sale! |
Support Low End Mac <http://lowendmac.com/lists/support.html>
G-Books list info: <http://lowendmac.com/lists/g-books.html> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/g-books%40mail.maclaunch.com/>
---------------------------------------------------------------
The Think Different Store
http://www.ThinkDifferentStore.com ---------------------------------------------------------------
