In a message dated 12/26/02 8:38:28 PM, [EMAIL PROTECTED] writes: << I have a G3/300 ZIF module that was pulled from a rev A beige G3 minitower. Shouldn't I be able to use this in a G3/233 All-In-One (rev B)? ... >>
Sure, the mobos are the same. Whenever you remove a ZIF, the jumper block for that ZIF should go with it. The jumper block is pre-programmed with all relevant parameters for that ZIF. The little bump on one end of the block indicates pin 1. -- G-List is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- We have Apple Refurbished Monitors in stock! | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> G-List list info: <http://lowendmac.com/lists/g-list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/g-list%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
