Carbon Copy Cloner help requested

[Len Gerstel]

I just picked up a new 160G HD for my beige. I am running 10.2.8. I 
have hooked it to an Acard ATA 133 card that is running my 80G boot HD 
fine. I formatted the disk with disk utility into 3 partitions, the 
first being 7.9G for OSX.

I have set the following preferences in Carbon Copy cloner:
Repair permissions before cloning
Delete directories before overwriting (can't hurt, even though the disk 
was just formatted)
Make bootable

When CCC finished cloning the HD (actually just one partition), I 
opened the system preferences and chose the startup disk pane. I then 
selected the cloned partition to start up from. When I start up with 
only the new disk attached, I get the blinking ? disk. When I start up 
with both disks attached and the new HD  selected in the Startup Disk 
preference pane, it still starts up from the old HD.

Any ideas on what I am doing wrong?

Thanks,
Len
Beige MT, G4 533, 768meg ram, 10.2.8, ACard ATA 133 card, Flashed 64meg 
Radeon 7000, Generic USB 2 card
80G HD, 160G HD, Toshiba 8x8x8x24 DVD/CDRW combo drive, 24x cd

--
G-List is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics    http://www.smalldog.com | Refurbished Drives |
-- We have Apple Refurbished Monitors in stock!  |  & CDRWs on Sale!  |
     Support Low End Mac <http://lowendmac.com/lists/support.html>

G-List list info:       <http://lowendmac.com/lists/g-list.shtml>
 --> AOL users, remove "mailto:";
Send list messages to:  <mailto:[EMAIL PROTECTED]>
To unsubscribe, email:  <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive: <http://www.mail-archive.com/g-list%40mail.maclaunch.com/>
Using a Mac? Free email & more at Applelinks! http://www.applelinks.com