Seagate Cheetah in B&W G3/450

[Maaki]

My recently acquired B&W G3/450, (Rev 2), arrived with an Apple OEM 
SCSI card and a 9GB IBM SCSI drive attached to the  end of the SCSI 
ribbon cable. I recently added a 120 GB ATA drive in the rear 
position.

My 50 pin 18 GB Seagate Barracuda drive which was in an external case 
attached to my 8500 died, and Seagate replaced it with a 68 pin 
Cheetah of the same size. (model ST318406LW)

<http://www.seagate.com/support/disc/specs/scsi/st318406lw.html>
It would seem I could add this Cheetah to the middle of the ribbon 
cable inside this B&W G3, assuming that I set the ID properly and 
left it un-terminated.  Is there anything else I should consider? 
e.g.  Heat? Term Power?

Maaki
--
G-List is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics    http://www.smalldog.com | Refurbished Drives |
-- We have Apple Refurbished Monitors in stock!  |  & CDRWs on Sale!  |
     Support Low End Mac <http://lowendmac.com/lists/support.html>
G-List list info:       <http://lowendmac.com/lists/g-list.shtml>
 --> AOL users, remove "mailto:";
Send list messages to:  <mailto:[EMAIL PROTECTED]>
To unsubscribe, email:  <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive: <http://www.mail-archive.com/g-list%40mail.maclaunch.com/>
Using a Mac? Free email & more at Applelinks! http://www.applelinks.com