It may be the case that you'll need to reset the CUDA (and, perhaps, the PRAM) before the B&W will properly work with the new card. As a rule, you should always reset the CUDA when changing hardware configurations on machines that have them.
There is a firmware update to allow G4s in the B&W, but it's not from Apple. You can find it at OWC <eshop.macsales.com> and probably other sites. On Nov 28, 2004, at 2:49 PM, george m clarkson wrote: > I have one new Raedon 7000 MAC Edition that I would like to install > but am confused by conflicting information. First, it was purchased > for the Beige, was improperly installed and damaged partially due to > poor instructions which resulted in a big mess and the unit was nicely > replaced at no charge by Radon. After getting my B&W I > unsuccessfully tried to install the new Radon. I had not noticed that > the new Radon requires a G4 processor. > > I understand that Apple does not support G4 on B&W. Is there a work > around to install a new G4 ZIF? -- G-List is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- We have Apple Refurbished Monitors in stock! | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> G-List list info: <http://lowendmac.com/lists/g-list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/g-list%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
