OK,I need some help.
On my B&W G3/400. 1Gb Ram, I was trying to replace the stock G3 with
an PowerLogix G4/500 chip.
To do it, I was to upgrade the firmware. It is running X (10.3) on
it, and I have tried to upgrade the firmware, with no luck, including
trying to run Classic mode.
It starts to run, then says "This update if for a PowerMac G3 only (I
was running the G3/400 chip at the time.
But, that is not the worse part.
Now, I reboot, and the Apple shows for a moment, and then flickers
off. It is replaced by a circle with a line through it.
That is it.
I reset the cuda switch, reset the PRAM, and still no luck
Any ideas what I did to this bad boy?
John
--
G-List is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics http://www.smalldog.com | Refurbished Drives |
-- We have Apple Refurbished Monitors in stock! | & CDRWs on Sale! |
Support Low End Mac <http://lowendmac.com/lists/support.html>
G-List list info: <http://lowendmac.com/lists/g-list.shtml>
--> AOL users, remove "mailto:";
Send list messages to: <mailto:[email protected]>
To unsubscribe, email: <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive: <http://www.mail-archive.com/g-list%40mail.maclaunch.com/>
iPod Accessories for Less
at 1-800-iPOD.COM
Fast Delivery, Low Price, Good Deal
www.1800ipod.com
