> I wanted to upgrade my children's (my old) G4 MDD 1.25 Dualie, 2 GB RAM, > OS10.5.4 to the 1.42 Ghz Dual processors and heat sink. > > The buss speed is 167 so I should have had no problems. > > However, when I swapped the processors, heat sinks (big brass one), > pressed the cuda button and then powered up and I get the "boing" but > the monitor displays nothing. I tried again and still the same, I have tried > using CMD + OPT + P + R and I do get the gray Apple but NO spinning wheel. I > again put everything back as it was and it started just fine and continues to > run.
Have you tried pulling out all the pci cards and starting up while holding the shift key for a safe boot? --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed Low End Mac's G3-5 List, a group for those using G3, G4, and G5 desktop Macs - with a particular focus on Power Macs. The list FAQ is at http://lowendmac.com/lists/g-list.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/g3-5-list?hl=en Low End Mac RSS feed at feed://lowendmac.com/feed.xml -~----------~----~----~----~------~----~------~--~---
