Hi Hubert, I've used the g4u programm several times with great pleasure, but now I run into a problem with the booting of a Dell Vostro 1510 laptop.
After the CD starts booitng, it panics pretty soon. This happens with both the 2.3 version and the 2.4alpha which I downloaded one hour ago. The last lines during boot are: PCI BIOS rev. 3.0 found at 0xfde11 PCI IRQ Routing Table rev. 1.0 found at 0xfdeb0, size 304 bytes (17 entries) pcibios_pir_init: bad IRQ table checksum uvm_fault(0xc06c2a00, 0x5000, 1) -> 0xe fatal page fault in supervisor mode trap type 6 code 0 eip c07f6e5d cs 8 eflags 10246 cr2 5c64 ilevel 8 panic: trap The operating system has halted. Please press any key to reboot. I tried all 3 options from the alpha release (normal mode, no ACPI, no ACPI, no SMP), but that did not make any difference. I also have similar error message if I run the 2.3 version, there are some small differences in the listed address in uvm_fault and in the trap type. Do you have any clue what is causing this? Is the laptop to modern to use the g4u programm (that would be a pitty because I really like your programm. It is so easy to resetup a system using the saved diskcopy). Is there options I can disable in the BIOS of the laptop to prevent the bios checksum error? Kind regards, Sjaak van Herpen Holland ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ g4u-help mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/g4u-help
