On 10/27/05, Branimir Ackovic <[EMAIL PROTECTED]> wrote: > > > > > Hi > > I use ganglia 3.0.1 and want to monitor 8 nodes on my grid cluster without > monitoring servers. I tried with several settings of gmetad but no > configuration works. Nodes have addresses from 147.91.83.201 to > 147.91.83.208. (wn01.phy.bg.ac.yu - wn08.phy.bg.ac.yu). Server with gmetad > and web interface is on 147.91.83.200 (paradox.phy.bg.ac.yu). All of them > are on same switch. On server I put in gmond.conf:
> data_source "AEGIS01-PHY-SCL" 147.91.83.201 147.91.83.202 147.91.83.203 > 147.91.83.204 147.91.83.205 147.91.83.206 147.91.83. > How can I set gmetad to se anly wn01-wn08. I also want to add some other > servers in Server group. They are on same switch and have also have > 147.91.83.xxx addresses. This was just answered in the archives in the last few days! data_source "AEGIS01-PHY-SCL" 147.91.83.201 147.91.83.202 147.91.83.203 147.91.83.204 147.91.83.205 147.91.83.206 147.91.83. <--maybe this is your problem line try: data_source "AEGIS01-PHY-SCL1" 147.91.83.201 data_source "AEGIS01-PHY-SCL2" 147.91.83.202 data_source "AEGIS01-PHY-SCL3" 147.91.83.203 ... The other thing might be that the TTL is too low (packets aren't reaching each other computer), or that your switch isn't multicast-compatable (in that case, you have to use unicast (requires monitoring server) or switch to a different router, or use a hub). This is all just guesses though, so take the advice with a grain of salt. -- ~Mike - Just my two cents - No man is an island, and no man is unable.
