Dear Tom
  ----- Original Message ----- 
  From: Thomas Reed 
  To: Discussion of biomass pyrolysis and gasification 
  Sent: Monday, December 19, 2011 1:29 PM
  Subject: Re: [Gasification] TLUD BEST


  Tom 


  When wood reaches 300C, an exothermic reaction takes over, and it goes 
spontaneously to 400-450 making a charcoal with little absorbtive capacity.  
The conventional updraft turf covered woodpile makes this type of charcoal.

  # Given that the biochar used to make Terra Preta was most likely made in the 
primitive manner, is there any reason to believe that such charcoal would be 
bad for use as biochar?

  Thanks!!

  Kevin Chisholm


  TLUD charcoal making requires a temperature > 500C to sustain the PYROLYTIC 
fire, so makes a charcoal with modest absorb tin capacity.  I am anxious to try 
the blanket or turf covered Pyromid in both TLUD and conventional mode and 
compare the charcoal properties.  


  I hope Hugh and Frank will weigh in on this discussion.


  Tom Reed



  Dr Thomas B Reed 
  The Biomass Energy Foundation
  www.Woodgas.com

  On Dec 17, 2011, at 12:40 PM, "Tom Miles" <[email protected]> wrote:


    Tom,



    Thanks for the observations.



    Burning forest slash is CO2 neutral at the very least. The benefits when 
the charcoal is used in the forest are in soil health and water quality. No 
doubt there are models that show the net improvement in the carbon cycle from 
carbonizing slash. 



    Blanket strips could be used just as you have suggested for the turf. 
Unlike the turf the blankets could be reused on several piles. The total cost 
of treatment should be less than using a portable kiln like a modified air 
curtain incinerator ( www.airburners.com ) or a mobile pyrolyzer to make oil 
(http://www.advbiorefineryinc.ca/technology/). 



    The benefit of using the TLUD approach is to have a cleaner burn than a 
typical earth kiln approach. 



    You're welcome to come out and stimulate our pyromania. 



    Happy Holidays



    Tom     



    From: [email protected] 
[mailto:[email protected]] On Behalf Of Thomas Reed
    Sent: Saturday, December 17, 2011 8:45 AM
    To: Discussion of biomass pyrolysis and gasification; Paul Anderson; Hugh 
McLaughlin; Kathy Nafie
    Cc: [email protected]
    Subject: [Gasification] TLUD BEST



    Tom Miles and all



    First let me reiterate the warning that TLUD charcoal making is not CO2 
negative unless you have also a use for the heat GENERATED in the pyrolysis gas 
fire.  Wood is 50% carbon, and if you get a 20% yield of charcoal, you have put 
30% back in the air as CO2 sooner than if the wood rotted.  So 1 ton of wood 
gave 400 lb of charcoal and (1600x44/12) 5.87 tons of CO2 into the atmosphere.



    Unless you cook or generate electricity with the heat, in which case you 
are doubly CO2 negative by replacing propane or other fossil fuel for cooking!

    <><><> 



    I like the idea of the blanket, but not the $1500 it would cost and the 
time it would take to develop.    How about TURF.



    Classic charcoal at the time of Napoleon ( he burned down the forests to 
make cannons) involved stacking many cords of wood around a central chimney 
made of poles and covering it with turf, leaving a smoke hole at the top.  
Small air entries were made at the base and fires lit.  For quite a while the 
smoke was white as water vapor was expelled amd the wood dried.  Then the smoke 
turned yellow, as pyrolysis began, and finally blue when the charcoal was 
burning.  Then seal the bottom up tight and wait another few days for it to 
cool.  Strip off the turf and you have a beautiful pile of charcoal.  



    I have been tempted to replicate the above method on a small scale in my 
back yard next  April when we are allowed to burn.  But I would substitute TOP 
LIGHTING with burning off of the pyrolysis gases as they are formed and 
regulation of the burn rate by adjusting the air inlet holes.  Make a TURFTLUD.



    I hope you will discuss this with your friends at UW.  I would even be 
willing to fly out for a meeting and maybe small tests if you have a secret 
burn spot.  



    Onward to more charcoal with cleaner air.



    Tom Reed,   Dr. PGas

    Dr Thomas B Reed 

    The Biomass Energy Foundation

    www.Woodgas.com


    On Dec 17, 2011, at 11:00 AM, "Tom Miles" <[email protected]> wrote:

      Tom,



      The pyromid looks like a good  in-woods approach to converting slash to 
biochar.



      Do you think that the pyrolysis blanket that is being developed by Carbon 
Cultures (Jenny Knoth U Washington) can be used to improve the performance of 
the pyromid? 



      See video and story at: 

      http://www.slideshare.net/sblank/carbon-cultures-corps-final

      http://www.igert.org/stories/90

      http://depts.washington.edu/bioenrgy/

      
http://www.myscience.us/wire/turning_slash_piles_into_soil_benefit-2011-washington



      Thanks



      Tom Miles



      From: [email protected] 
[mailto:[email protected]] On Behalf Of Thomas Reed
      Sent: Saturday, December 17, 2011 6:43 AM
      To: Discussion of biomass pyrolysis and gasification; STOVES
      Subject: Re: [Gasification] gasifier type updarft use rice husk



      Dear gassers and Stovers



      Using any size TLUD device including an open PYROMID, and any junk 
biomass, we all have easy access to as much charcoal as we could ever need, for 
the first time in history.



      Furthermore, Hugh McLaughlin tells me that, while it's not true activated 
charcoal, made with steam or CO2 at 800C, it has significant absorption 
capacity (iodine no 400?) since it is made at 500-800 C.  I hope Hugh or Frank 
will comment.  



      So we really have no excuse for cleaning up TLUD gas if we wish to.  



      I'm waiting for a good analysis of TLUD gas.  I suspect after cleaning it 
will have significantly more energy than the typical 5.5 MJ/m3 or 150 Btu/ scf 
of downdraft Woodgas, since the air fuel ratio for pyrolysis is only 1-1.5, 
rather than the 3.5 for complete gasification of the cellulose lignin package 
that is wood.   So, as a first guess, with 1/3 the A/F ratio, I'm guessing 3x 
the energy content, of 4.5 MJ/m3 or 450 Btu/scf.  Compare to natural gas at 
1000 Btu/ scf. 



      I'd sure like to see some comments from all you practical guys (and 
dolls?) out there.  



      Onward 



      Tom Reed.   Dr WoodGas







      Dr Thomas B Reed 

      The Biomass Energy Foundation

      www.Woodgas.com





      _______________________________________________
      Gasification mailing list

      to Send a Message to the list, use the email address
      [email protected]

      to UNSUBSCRIBE or Change your List Settings use the web page
      
http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org

      for more Gasifiers,  News and Information see our web site:
      http://gasifiers.bioenergylists.org/

    _______________________________________________
    Gasification mailing list

    to Send a Message to the list, use the email address
    [email protected]

    to UNSUBSCRIBE or Change your List Settings use the web page
    
http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org

    for more Gasifiers,  News and Information see our web site:
    http://gasifiers.bioenergylists.org/



------------------------------------------------------------------------------


  _______________________________________________
  Gasification mailing list

  to Send a Message to the list, use the email address
  [email protected]

  to UNSUBSCRIBE or Change your List Settings use the web page
  
http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org

  for more Gasifiers,  News and Information see our web site:
  http://gasifiers.bioenergylists.org/



------------------------------------------------------------------------------


  No virus found in this message.
  Checked by AVG - www.avg.com
  Version: 2012.0.1890 / Virus Database: 2108/4690 - Release Date: 12/19/11
_______________________________________________
Gasification mailing list

to Send a Message to the list, use the email address
[email protected]

to UNSUBSCRIBE or Change your List Settings use the web page
http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org

for more Gasifiers,  News and Information see our web site:
http://gasifiers.bioenergylists.org/

Reply via email to