Hi Jeff, The easiest way is to set up a controllable blower on the air intake of the gasifier. You then have a control ball valve to both engines (hopefully the same type and size). The fan cannot blow more than is let out through the valves, but should blow enough to start each engine on no load. It takes a bit of fiddling to get the first start up sorted, but then turn off the fan, open the valves fully, and apply the load to the max.
The gasifier should be able to run only one engine if the load drops below the max output of just one engine, so turn one engine off. If you find the oxidation temperature and colour dropping down to below a healthy incandescence on the one engine, you will need to increase the air velocity by using a slightly smaller air nozzle bore size. Hope this may be of some assistance. Doug Williams, Fluidyne. On Sun, 29 Mar 2015 20:47:47 -0400 Jeff Davis <[email protected]> wrote: > Dear List, > > Is it practical to fuel two engines with one gas producer? I think a check > valve in each fuel line would be needed but would it be a problem to get > the second engine running? My system would consist of a charcoal gas > producer with two 6.5hp engines. > > Thanks, > Jeff > > ______________________________________________ > "Once an owner has got used to charcoal gas he will never revert to the > more expensive fuels", Geo Bray -- Doug Williams <[email protected]> _______________________________________________ Gasification mailing list to Send a Message to the list, use the email address [email protected] to UNSUBSCRIBE or Change your List Settings use the web page http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org for more Gasifiers, News and Information see our web site: http://gasifiers.bioenergylists.org/
