Jonas,
Your best bet is to set up an in bound tunnel using port 25 and then
provide the Remote Access filter from 0.0.0.0 to the external ip address of
your firewall. There is an example of this in the manual under appendix C,
example 1. It is showing 4 tunnels (web, ftp, DNS and e-mail). In your
case you would only need the one tunnel. However, if your DNS is behind
the firewall your most likely going to need the tunnel and filter set up,
as well.
Corey Hudson
Midwest Library Service
At 04:19 PM 5/23/2002 +0200, Jonas Jacobsson wrote:
>Hi,
>
>I'm trying to connect from the external interface
>with SNMP to a host on the internal network. But I
>can't get it to work.
>
>Can anyone tell me how I should do? How do I write
>the filter? Should I use IP pass through?
>
>External ip: www.xxx.yyy.zzz ("Internet")
>Internal ip: 192.168.10.2 (NAT)
>Protocol: UDP/SNMP (I'm running mrtg on the external host)
>
>Thanks in advance.
>
>/jonas
>
>
>
>---------------------------------------------------------------------
>To unsubscribe, e-mail: [EMAIL PROTECTED]
>To subscribe to the digest version first unsubscribe, then
> e-mail: [EMAIL PROTECTED]
>For additional commands, e-mail: [EMAIL PROTECTED]
>Archive of the last 1000 messages:
> http://www.mail-archive.com/[email protected]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
To subscribe to the digest version first unsubscribe, then
e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
Archive of the last 1000 messages:
http://www.mail-archive.com/[email protected]
