I've been trying to get VPN to work between two GB-1000 units. It shouldn't
be this difficult. I know I'm missing something simple.
Configurations:
GB-1000 #1 (version 3.2.1)
Protected network: 192.168.1.0/24 Interface: 192.168.1.1
External network: 1.1.1.0/29 Interface: 1.1.1.1
VPN local gateway: 1.1.1.1 Remote gateway: 2.2.2.1
Local network: 192.168.1.0/24 Remote network: 192.168.2.0/24
GB-1000 #2. (version 3.2.5s)
Protected Network: 192.168.2.0/24 Interface 192.168.2.1
External Network: 2.2.2.0/29 Interface 2.2.2.1
VPN remote gateway: 1.1.1.1 Remote network: 192.168.1.0
Note: In version 3.2.1 there are boxes for both local and remote gateway
and networks. In version there are boxes for only remote gateway and
network. And that makes sense to me.
Both GB-1000 boxes show an active VPN connection to the remote GB-1000 in a
'mature' state.
My hang up is that I don't understand how to route packets to the remote
network. According to the VPN documentation, outbound destination addresses
are compared to the remote network addresses defined in the VPN section, and
if there is a match, and if there is an appropriate IP pass through rule,
the packet is sent through the tunnel.
If while I am logged on to GB-1000 #2 I do a trace route to 192.168.1.1, the
packet is sent out the external port because there is no route for that
address. It uses the default route. My understanding is that because it is
within the remote network defined for the VPN, it should be routed through
the tunnel.
Now for my question. What do I need to do to get packets for a remote VPN
network routed through the VPN tunnel?
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
To subscribe to the digest version first unsubscribe, then
e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
Archive of the last 1000 messages:
http://www.mail-archive.com/[email protected]
