On Thu, 2008-01-10 at 06:36 -0500, Stuart Brorson wrote: > > The new release of gerbv is a vast improvement over the previous version. > > I especially like the interface improvements. The only downside that I > > noticed was the appearance of vertical lines in sliced PCB polygons when > > "high quality" rendering is selected. These artifacts did not appear in > > Normal or Fast modes. > > Thanks for the report. Do you have a Gerber layer you could share with > us as we look into debugging the vertical line problem?
This is caused by abutting polygons which happen to fall on a non device coordinate boundary at render time. Make a new PCB in PCB, stick a plane in it, and drop some vias to cut into it. PCB dices this up into separate polygons, and it should trigger the rendering glitch when you export the gerber file and view it. -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-dev mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev
