> Strange. I'm sure the postscript is drawing those faint lines but > they shouldn't be visible since they are on top of or beneath a > solid fill. (The slices share a common edge where the line appears.) > Does your printed postscript show those lines (or worse gaps)?
The prints appear OK. Both ghostview and acroread have faint white lines between the slices, and not always - it depends on the zoom factor. I suspect it's due to the antialiasing since it only happens when antialiasing is on, but it makes me wonder if these edges shouldn't be overlapped by a bit (1/100 thou?) or not. I also don't know what the fab's DRC/DFM would do with the thin slices or just-touching edges. gerbv seems to draw it OK too. I wouldn't have been too concerned about it except that these are internal layers on my board, so I can't visually inspect the results from the fab. _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
