Britton, you make one symbol lm324.sym.
for each pin you add a pin sequence. typically you use the 1st slots pins and add a pinnumber=2 to the pin as well then you add an attribute slot=1:2,4,6,8 then another attribute slot=2:1,3,5,7 picking a slot at the schematic level substitues the pin numbers from the slot attribute have fun, Steve M. Britton Kerin wrote: > I have design on subsheet, containing single op amp. > > I tried making another symbol for the part called > lm324--slot_2.sym, the other difference being it > gets a slot=2 attribute instead of slot=1. > I then created sub_design--slot_2.sch using this > part. Finally, I used 'source=sub_design--slot_2.sch' > in my top level design for the second repetition of > the module. But pcb still gets two chip outlines > with only the first slot of each used. > > This makes me think that more is required than an > ability to override the attributes of a sub-sheet > to get slots to work accross sub-designs. > > I have checked out the source and could try to help > with this issue, given a pointer or two where to > start. > > Britton > > > > > _______________________________________________ > geda-user mailing list > [email protected] > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > > _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
