opps that should be a slotdef=2:2,4,6,8 you might also need
a numslots=2 in my example Steve M Steve Meier wrote: > Britton, > > you make one symbol lm324.sym. > > for each pin you add a pin sequence. > typically you use the 1st slots pins and add a pinnumber=2 to the pin as > well > > then you add an attribute > slot=1:2,4,6,8 > then another attribute > slot=2:1,3,5,7 > > picking a slot at the schematic level substitues the pin numbers from > the slot attribute > > have fun, > > Steve M. > > Britton Kerin wrote: > >> I have design on subsheet, containing single op amp. >> >> I tried making another symbol for the part called >> lm324--slot_2.sym, the other difference being it >> gets a slot=2 attribute instead of slot=1. >> I then created sub_design--slot_2.sch using this >> part. Finally, I used 'source=sub_design--slot_2.sch' >> in my top level design for the second repetition of >> the module. But pcb still gets two chip outlines >> with only the first slot of each used. >> >> This makes me think that more is required than an >> ability to override the attributes of a sub-sheet >> to get slots to work accross sub-designs. >> >> I have checked out the source and could try to help >> with this issue, given a pointer or two where to >> start. >> >> Britton >> >> >> >> >> _______________________________________________ >> geda-user mailing list >> [email protected] >> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user >> >> >> > > > > _______________________________________________ > geda-user mailing list > [email protected] > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > > _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
