On Fri, 2007-07-27 at 13:35 -0400, John Luciani wrote: > On 7/27/07, armdeveloper <[EMAIL PROTECTED]> wrote: > > I had to hand route that because the footprint pin > > identifiers didn't match the symbol. > > Hand routing is a very bad idea. You should create a set of symbols and > footprints that match so that your schematic and PCB are always in sync. > > You could post a *simple* schematic and PCB that demostrate the > problem.
I agree that hand routing is bad. Go back and look at the suggested solutions to some of my header questions and manual layout/ hand routing was suggested, as far as I can tell. I'm finding footprints in pcb to be a large headache. As a matter of fact, the majority of my time has been spent messing around with footprints. Is anyone working on a footprint viewer/editor ? Kind of like gschem has a symbol editor ? Excuse my ignorance... Thanks. _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
