On Fri, Mar 14, 2008 at 08:04:41AM -0700, Traylor Roger wrote: > Guys, > In Settings -> Sizes > -I have min annulus ring set to 5mil. > -Minimum copper width is set to 8mil. > > My vias have a 10mil drill, 21mil outer > diameter. This should yield a 5.5mil > annular radius on the vias. > > When doing DRC, it complains with: > "Via annular ring is too small based on minimum > copper width near location ...."
In my opinion it's a bug. I have that test commented out in my local copy. Just as you say, it applies BOTH min copper AND min annulus to holes. I did a board with similar rules to yours (6/6 with 5 annulus) and got thoes initially. -- Ben Jackson AD7GD <[EMAIL PROTECTED]> http://www.ben.com/ _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
