On Sat, 2008-05-24 at 22:25 -0400, Rick Collins wrote: > Is there a reason that this can't be fixed in this software, either > by making it impossible to place pins off grid or by having the > software capable of making connections to pins that are off grid? Or > perhaps the software should check this and give a warning when > placing a part so that it is not connectable. Or a final suggestion, > a means of easily correcting all parts that are off grid...
Magnetic nets mode might be the way to allow this. -- Peter Clifton Electrical Engineering Division, Engineering Department, University of Cambridge, 9, JJ Thomson Avenue, Cambridge CB3 0FA Tel: +44 (0)7729 980173 - (No signal in the lab!) _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
