On Sat, Oct 25, 2008 at 4:45 PM, DJ Delorie <[EMAIL PROTECTED]> wrote: > > Check your "shrink" size. In your case, it's set to 10 mil, which > means any two touching copper segments must overlap by at least 10 > mil. You have some segments that only overlap by 3 mil. > > You can set this smaller if your process doesn't care about checking > for misaligned segments causing opens (old photoplotters drew each > segment mechanically, new processes almost always rasterize and don't > need to check for shrink). >
OK, that helps a lot. Thank you. Regards, Mark [EMAIL PROTECTED] -- Mark Rages, Engineer Midwest Telecine LLC [EMAIL PROTECTED] _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
