Am Samstag, den 22.11.2008, 23:22 +0000 schrieb Peter Clifton: > On Sat, 2008-11-22 at 21:52 +0100, Stefan Salewski wrote: > > pcb 20080202 (GTK) > > > > If Auto enforce DRC clearance is on, lines (traces) starting from a pad > > always snap to one of the pad endpoints. It is impossible to start the > > line from an arbitrary grid point over the pad. > > Even if you hold down the shift key when starting the trace? >
SHIFT makes no difference for this bug -- "Crosshair snaps to pins and pads" is off, "Auto enforce DRC clearance" is on. Snaps to pad endpoints. If I switch "Auto enforce DRC clearance" off snap to grid points works fine as desired. _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
