Am Samstag, den 22.11.2008, 16:19 -0800 schrieb Ben Jackson: > On Sun, Nov 23, 2008 at 12:33:33AM +0100, Stefan Salewski wrote: > > > > SHIFT makes no difference for this bug -- "Crosshair snaps to pins and > > pads" is off, "Auto enforce DRC clearance" is on. Snaps to pad > > endpoints. If I switch "Auto enforce DRC clearance" off snap to grid > > points works fine as desired. > > I haven't tried your board, but try turning on the visible DRC clearance. > It may be that you're not getting snapping, just a fine pin pitch plus > large clearance only leaves a narrow gap where the line can go. >
Tried "Crosshair shows DRC clearance", makes no difference, and give me no hint. There is no fine pitch for my example, its a very large pad. Try pads of SSP100 on left upper corner of my board. For a device with large pads this bug is easy visible. But of course it seems to exists for all pads. Best regards Stefan Salewski _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
