>> Is there a way in PCB to get "doughtnut" pads for pins and vias rather >> than solid fills? > > There is a drill helper in pcb postscript output, see pcb print- or > postscript-dialog. Or search for term drill helper in mailing list > archive.
Thanks, Stefan. I've been so fixated on Gerber export I didn't think to try the postscript output. Cheers Gareth Stefan Salewski wrote: > Am Freitag, den 12.12.2008, 18:22 +0000 schrieb > [email protected]: >> Apologies if this has been answered in the archives but my searches >> haven't thrown anything up (is there a direct search of the mailing list >> archive available?) >> > > You may try Google with > > site:geda.seul.org searchterm > > >> Is there a way in PCB to get "doughtnut" pads for pins and vias rather >> than solid fills? In the past, I've used such a thing to assist with >> hand-drilling - a very small copper-clear area in the middle of a pad >> will centre the drill nicely if I drill after etching. >> >> Getting closer to making that board... >> > > There is a drill helper in pcb postscript output, see pcb print- or > postscript-dialog. Or search for term drill helper in mailing list > archive. > > > > > > > > _______________________________________________ > geda-user mailing list > [email protected] > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user > > _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
