On Wed, Dec 31, 2008 at 8:17 PM, Saritha Kalyanam <[email protected]> wrote: > > The following footprint gives a DRC error "copper areas too close" > [1]http://www.gedasymbols.org/footprints/m4lib/LQFP48_7.fp > The pads are most likely 9 mils apart instead of 10 mils. > Saritha
I have not looked at the spec but I would be surprised if the pads could get much narrower and have a reliable solder joint. 10/10 design rules are probably no practical for "common" SMD components. 8/8 would be a more reasonable setting. (* jcl *) -- http://www.luciani.org _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
